Construction Notices of Silicone Thermal Conductive Adhesive

1. Clean up the surface of the sticky or coated material, remove rust, dust and grease, etc.

2. Turn off the cap of the hose and squeeze the glue onto the cleaned surface to make it evenly distributed, and then close and fix the adhesive surface. 

3. Place the bonded or sealed parts in the air and let them solidify naturally. 
The curing process is a surface-to-interior curing process. Within 24 hours (room temperature and 50% relative humidity), the adhesive will be cured at a depth of 2-4 mm. If the position is deep, especially where it is not easy to touch the air, the time of complete curing will be prolonged. If the temperature is lower, the curing time will also be prolonged, and it will be further treated or sticked. Before packaging the knotted parts, it is recommended that the user wait long enough to ensure the firmness and integrity of the bonding is not affected. Notes: After the operation is completed, the unused glue should tighten the cap immediately, seal and preserve, and when it is used again, if there is a little crust at the seal, it can be removed without affecting the normal use.